Author Topic: Homemade broadheads  (Read 6624 times)

0 Members and 1 Guest are viewing this topic.

Offline Rancid Crabtree

  • Sr. Member
  • ****
  • Posts: 389
  • Karma: 1
  • Happy to be here
    • View Profile
Homemade broadheads
« on: October 24, 2007, 06:04:59 AM »
Since attending the big Trad shoot in Michigan (Compton) left me without any broadheads for this years hunt, I needed to make more.

I use 125 grain field points and reshape them to remove the shoulders. this step may not be necessary buy It looks nice.
   
the blades are cut from a .039 thick bandsaw blade.



the jig for slotting the field point is made of steel and clamps the point while the spacer (piece of hacksaw blade) Leaves room for the saw to pass between the two halves to cut the slot.







I then polish the two pieces and make sure I have a good fit up.





Next I braze the two parts together although I think solder or even J.B. Weld would suffice. I may try this on the next batch because brazing is messy and I have to quench afterward to make sure the heads are hard.



After cleaning and polishing again, I use a cold bluing to protect the heads and then a light coat of oil.
 

Finished weight, 165 grains. about 1 inch wide (15/16) and 1 1/4 long.





Next, I tried a single bevel design. It makes a lot os sense.



In the end. I changed my thinking and went with a longer blade design for my heads. I still use the single bevel but liked the longer design for increased penetration. I added a pinned arragement for added strength.


Any day in the woods is a good day.

 

Google
Web http://www.wisconsinoutdoor.com